![[Tiger 321]](321_1.gif)
|
Option Pack 1 - Bench Assembly Assembly of the radio control gear needs to be done on a bench to ensure that the equipment operates properly. The information on this web page are to be used as a visual guide with the instructions supplied by Armortek. Follow the Armortek instructions very carefully. The wiring schematic that Armortek provided for the original Option Pack 1 is here. I've added black braided nylon wiring sleeves where possible to reduce abrasion hazards to the wiring. The wiring sub looms were also labeled to make them easier to find. |
|
) |
Connecting
the main motors to each of the electronic speed control relays. These
are not the 4QD speed controllers that Armortek now supplies. |
) |
Connecting
the power supply leads on the electronic speed controllers to the
power output cables from fuse box glands 3 & 4. |
) |
Connecting
the first electronic switch unit to the switch unit sub loom labeled
"1". I added the number "1" on the switch. |
) |
Connecting
the second electronic switch unit to the switch unit sub loom labeled
"2". I added the number "2" on the switch. |
) |
Connecting
the turret rotation motor to the rotation motor sub loom using the
two-way shrouded connector. |
) |
Connecting
the switch unit sub loom to auxiliary unit power supply cables from
fuse box gland 5. |
) |
Connect
the turret sub loom to the switch unit sub loom using the eight way
connector. This is a difficult connector to use for the first time.
I'd recommend finding a spare spade connector and inserting it into
each female connector of the 8 way to loosen them up. Connect the
elevation motor to the turret sub loom. |
 |
Connecting
the recoil servo to the servo socket on the turret sub loom. |
) |
Connecting
the elevation motor limit switches to the turret sub loom. |
